Skirting & cornice stock lengths

MEASURE FIRST

How to prepare your inputs

Use the actual material dimensions and a dimensioned plan. Allow for offcuts and distinguish nominal timber names from finished sizes.

How this calculation works

Required length = measured run × allowance. Minimum stock count = ceil(required length ÷ stock length).

Assumptions & exclusions

An aggregate lower bound, not a cutting plan. Individual runs, mitres, scarf joints and reusable offcuts may require more stock. Measure each run before ordering.

Your next step

Prepare a cutting list and check spans, grades, joints and fixings with the project designer.

Further reading

• Blocklayer geometric tool directory

These resources provide background information. Confirm current product specifications and project requirements with your supplier or trade professional.

What if my shape or product is different?

Use dimensions and product data that match the stated method. For complex work, calculate separate sections or obtain a project-specific take-off. Do not apply simple geometry to structural or compliance decisions.

Why are quantities rounded up?

Whole bags, packs, sheets or cartridges round up to purchasable units. Decimal area or volume results are planning figures; confirm order increments with the supplier.

Are my entries saved?

No. Entries remain in the current browser page and clear on reload. Printing can save your results and inputs as a PDF on your device.